Optical Density (OD)

Optical Density (OD) is a logarithmic unit used to quantify the attenuation (blocking) of light as it passes through an optical component. In the context of optical filters and safety eyewear, it is the standard metric for describing how effectively a material blocks or rejects out-of-band wavelengths.

Because OD is a logarithmic scale, it is much easier to read and communicate than percentage transmission when dealing with high-performance blocking (e.g., "OD 6" vs. "0.000001%").

The Formula

Optical Density is calculated based on the transmittance (T) of the optic, where T is a value between 0 and 1.

OD = -log10(T)

  • To find Transmission from OD: T = 10-OD

OD vs. Transmission Table

A small increase in Optical Density represents a significant decrease in the amount of light that passes through.

Optical Density (OD) Transmission (%) Attenuation Factor Typical Application
OD 0 100% 1 Transparent glass (approx.)
OD 1 10% 10 Sunglasses / ND Filters
OD 2 1% 100 General light reduction
OD 3 0.10% 1,000 Laser safety (low power)
OD 4 0.01% 10,000 Fluorescence excitation filters
OD 5 0.00% 100,000 High-performance laser blocking
OD 6 0.00% 1,000,000 Raman spectroscopy / Safety

Key Characteristics

  • Logarithmic Scaling: OD allows engineers to easily compare vast differences in blocking performance without counting zeros (e.g., OD 4 vs OD 6).
  • Additivity: When stacking multiple absorptive filters, you can often add their OD values to estimate the total blocking. For example, an OD 1 filter stacked with an OD 2 filter results in a total system blocking of OD 3 (0.1% transmission).

Practical Example: Laser Safety

One of the most common uses of OD is in specifying laser safety eyewear.

  • Scenario: You are working with a 532 nm (green) laser with an output power of 100 mW (milliwatts). This is powerful enough to cause instant eye damage.
  • The Component: Safety goggles rated at OD 3 for 532 nm.
  • The Calculation:
    • OD 3 corresponds to a transmission factor of 10-3 (or 0.001).
    • 100 mW (Input) × 0.001 = 0.1 mW (Output)
  • The Result: The goggles block 99.9% of the laser light, reducing the power to 0.1 mW, which is generally safe for accidental momentary exposure.
Back to blog